Home » Engine » Fuel Injector Cleaning » How to do A Professional Fuel Injector Cleaning On the Vehicle

How to do A Professional Fuel Injector Cleaning On the Vehicle

RELATED PRODUCTS:

12 comments

  1. Where did you buy the kit?

  2. good idea… bad lighting… lost me, trying to figure why you would you make a video in the dark…

  3. what if the car has been sitting and will not start, b/c fuel injectors are clogged. from old gas?

  4. i have yet to see a road test before and after doing this job….will i be able to spin my tires again?

  5. Just one more thing…that you forgot to block the return line because it will return to the tank even if you drop the pressure.
    Plus you don't need to connect that "t" adaptor because it's going to put pressure on your fuel pump so you could damage it.
    Just saying 🙂 

  6. Good Presentation.

  7. ZZZZZZZZZZZZZZZZZZZZZZZZZZZ this retard is in the dark.. Literally

  8. ZZZZZzzzz… WHAT WHEN WHO WHY …oh there clean

  9. that would be fine, I can't see why not.

  10. Unless you wanted to use the fuel line adapter on another car, couldn't you just leave the tee inline on the fuel line for the next time?

  11. The 4.3 vortec engine has a larger injector that feed pintle tubes that inject the fuel into each cylinder. It is very common for the spider pintles to clog and cause problems. You could try using a injector cleaner like in the video, but many times they are too clogged and will need replacing.

  12. what would I try doing if my 2003 Blazer 4.3 will start & immediately dies, but if I prime it directly manually it stays running as soon as I stop it dies

Leave a Reply

Your email address will not be published. Required fields are marked *

*

x

Check Also

DIY: Clean Fuel Injectors, Get Better MPG, Get More Horsepower with Seafoam

DIY: Clean Fuel Injectors, Get Better MPG, Get More Horsepower with Seafoam

RELATED PRODUCTS: